SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2008TSX STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSKEYLESS/POWER DOOR LOCKS/SECURITY SYSTEMTRANSMITTER PROGRAMMING
2008 Acura TSX Standard

Transmitter Programming

2008 Acura TSX StandardSECTION Transmitter Programming

Storing transmitter codes:

The codes of up to three transmitters can be stored into the keyless receiver unit memory. (If a fourth code is stored, the code which was input first will be erased.)

NOTE: It is important to maintain the time limits between the steps. Make sure the doors, the hood and the tailgate are closed.
  1. Turn the ignition switch ON (II).
  2. Within 1 to 4 sec, press the transmitter lock or unlock button with the transmitter aimed at the keyless receiver in the power window master switch.
  3. Within 1 to 4 sec, turn the ignition switch OFF.
  4. Within 1 to 4 sec, turn the ignition switch ON (II).
  5. Repeat steps  2 to  4 two more times.
  6. Within 1 to 4 sec, press the transmitter lock or unlock button with the transmitter aimed at the keyless receiver in the power window master switch.
  7. Confirm you can hear the sound of the door lock actuators within 1 to 4 sec, then push the transmitter lock or unlock button again, or the code will not be stored.
  8. Within 10 sec, aim the transmitters (up to two additional ones) whose codes you want to store in the keyless receiver, and press the transmitter lock or unlock buttons.

    Confirm that you can hear the sound of the door lock actuators after each transmitter code is stored.

  9. Turn the ignition switch OFF, and remove the key.
  10. Confirm proper operation with the transmitters.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.