Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Acura TSX L4-2.4LFACTORY OEM SERVICE PROCEDURE
Subframe: Service and Repair
Subframe Replacement
Front Subframe Torque
After removing the subframe mounting special bolts, be sure to replace them with new ones.

Front Subframe Alignment
NOTE:
- Before removing the subframe, make reference marks on the subframe that line up with the edge of the rear bracket for reinstallation.
- When installing, align both installation reference holes in the subframe with the reference holes in the body using a screwdriver or tapered punch as a guide.
- After mounting the subframe and brackets loosely, align the reference marks with the edge of the rear bracket then tighten the bolts.

Rear Subframe Torque
After removing the subframe mounting special bolts, be sure to replace them with new ones.

Front Subframe Torque
After removing the subframe mounting special bolts, be sure to replace them with new ones.
Front Subframe Alignment
NOTE:
- Before removing the subframe, make reference marks on the subframe that line up with the edge of the rear bracket for reinstallation.
- When installing, align both installation reference holes in the subframe with the reference holes in the body using a screwdriver or tapered punch as a guide.
- After mounting the subframe and brackets loosely, align the reference marks with the edge of the rear bracket then tighten the bolts.
Rear Subframe Torque
After removing the subframe mounting special bolts, be sure to replace them with new ones.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
