SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2008TSX AUTOMATICREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSMISSIONTRANSMISSION END COVERPARK LEVER STOP INSPECTION AND ADJUSTMENT
2008 Acura TSX Automatic

Park Lever Stop Inspection and Adjustment

2008 Acura TSX AutomaticSECTION Park Lever Stop Inspection and Adjustment
  1. Set the park lever in the P position.
  2. Measure the distance (A) between the park pawl shaft (B) and the park lever roller pin (C).

    Standard: 57.7-58.7 mm (2.27-2.31 in.) 

    Fig 1: Identifying Distance Between Park Pawl Shaft And Park Lever Roller Pin
    G05491512Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. If the measurement is out of standard, select and install the appropriate park lever stop (A) from the table.
    Fig 2: Identifying Park Lever Stop
    G05491513Courtesy of AMERICAN HONDA MOTOR CO., INC.

    PARK LEVER STOP 

    PARK LEVER STOP AND PART NUMBER SPECIFICATION

    Mark Part Number B C
    1 24537-PA9-003 11.00 mm (0.433 in.) 11.00 mm (0.433 in.)
    2 24538-PA9-003 10.80 mm (0.425 in.) 10.65 mm (0.419 in.)
    3 24539-PA9-003 10.60 mm (0.417 in.) 10.30 mm (0.406 in.)
  4. After replacing the park lever stop, make sure the distance is within tolerance.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.