SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2008TSX AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR BODY PANELSFENDERWELLFRONT INNER FENDER REPLACEMENT
2008 Acura TSX Automatic

Front Inner Fender Replacement

2008 Acura TSX AutomaticSECTION Front Inner Fender Replacement
NOTE: Take care not to scratch the body.
  1. Remove the front inner fender (A).
    1. On the back of the wheel arch, remove the screws (B) If equipped, remove the front splash guard (C) (Canada models).
    2. From under the front bumper (D), remove the bolts (E) securing the front bumper, splash shield (F), and front inner fender, and remove the clip (G) securing the front bumper and front inner fender.
    3. From the wheel arch, remove the clips (H, I, J) securing the front inner fender (and splash shield) on the body.
    4. Release the hook (K) of the splash shield, then remove the front inner fender.
      Fig 1: Front Inner Fender W/Torque Specification
      G05492551Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Install the inner fender in the reverse order of removal, and note these items:
    • Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
    • Push the clips into place securely.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.