Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2008TSX AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEEXTERIOR/INTERIOR TRIMEXTERIOR TRIMREAR LICENSE TRIM REPLACEMENT
2008 Acura TSX Automatic
Rear License Trim Replacement
2008 Acura TSX AutomaticSECTION Rear License Trim Replacement
- Remove the inner taillight, one side (see INNER TAILLIGHT ).
- Detach the clips, and on both sides of the rear license trim (A), release the edge of the trim from the inner taillight (B), then remove the trim. Take care not to scratch the trunk lid.
- Install the trim in the reverse order of removal, and note these items:
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Push the clip portions into place securely.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.