Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Switch Test
2008 Acura RLSECTION Switch Test
- Remove the roof console (see ROOF CONSOLE REPLACEMENT ).
- Disconnect the 28P connector (A) from the roof console (B).
- Check for continuity between the No. 11 and No. 12 terminals.
- There should be continuity when the switch is pushed.
- There should be no continuity when the switch is released.
- If the continuity is not as specified, replace the roof console (see ROOF CONSOLE REPLACEMENT ).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.