Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Torque Specifications
2008 Acura RDXSECTION Torque Specifications
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Axle U-bolt nut | 225 | 166 | - |
| Axle vent | 3 | - | 27 |
| Bearing cap bolt | 108 | 80 | - |
| Brake caliper anchor plate bolt | 173 | 128 | - |
| Center bracket bolt | 17 | - | 150 |
| Differential case bolt (Grade 8) | 92 | 68 | - |
| Differential case bolt (Grade 9) | 129 | 95 | - |
| Differential housing cover bolt (Grade 5) | 47 | 35 | - |
| Differential housing cover bolt (Grade 8) | 61 | 45 | - |
| Differential pinion lock shaft screw | 27 | 20 | - |
| Differential ring gear bolt (Grade 8) | 176 | 130 | - |
| Differential ring gear bolt (Grade 9) | 176 | 130 | - |
| Driveshaft flange yoke-to-pinion flange bolt | 112 | 83 | - |
| Lower shock absorber nut | 79 | 58 | - |
| Oil filler plug | 34 | 25 | - |
| Park brake cable retainer bolt | 20 | - | 177 |
| Pinion flange nut | 339 | 250 | - |
| Stabilizer bar clamp bolt | 28 | 21 | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.