SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2008RDXREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSPOWER WINDOWSPOWER WINDOW SWITCH REPLACEMENTFRONT PASSENGER'S
2008 Acura RDX

Front passenger's

2008 Acura RDXSECTION Front passenger's
  1. Removal the front passenger's door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION ).
  2. Disconnect the 14P connector (A) from the power window switch.
    Fig 1: Disconnecting 14P Connector From Power Window Switch
    G05446464Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the front passenger's door sub harness (B) from the power window switch.
  4. Remove the three screws from the door panel, then pull up on the door pocket (C) to release the clips.
  5. Remove the three screws and the power window switch (A) from the door panel.
    Fig 2: Removing/Installing Power Window Switch At Front Passenger's Door Panel
    G05446465Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Remove the four screws and the power window switch.
  7. Install the switch in the reverse order of removal.
  8. After replacement, reset the power window control unit (see RESETTING THE POWER WINDOW CONTROL UNIT ).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.