Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2008RDXREPAIR AND DIAGNOSISBODY & FRAMESUN ROOF/T-TOP/CONVERTIBLE TOPPOWER MOONROOFMOONROOF SWITCH TEST/REPLACEMENT
2008 Acura RDX
Moonroof Switch Test/Replacement
2008 Acura RDXSECTION Moonroof Switch Test/Replacement
- Carefully pry off the lens with a small screwdriver (see FRONT INDIVIDUAL MAP LIGHT REPLACEMENT ).
- Pull down the roof console (A) holding the center part of the roof console.
- Carefully push out the moonroof switch (B) from behind the roof console, then disconnect the 7P connector (C) from the switch.
- Check for continuity between the terminals in each switch position according to Fig 2.
- If the continuity check is not as specified, check the bulb. If the bulb is OK, replace the switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.