Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSACURA2008RDXREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTNAVIGATION SYSTEMDVD-ROM REPLACEMENT

2008 Acura RDX

DVD-ROM Replacement

2008 Acura RDXSECTION DVD-ROM Replacement

NOTE:

When the DVD-ROM is re-inserted Or replaced, a map match must be done (see MAP MATCHING ). This system uses a white labeled DVD (possibly gray for Canada).
Check any official Honda service Web site for more service information about the navigation system.

Remove the passenger's console trim (see CENTER CONSOLE REMOVAL/INSTALLATION ).
Turn the ignition switch to ON (II).
Push the open button (A) located on the right side of the navigation unit.

Fig 1: Identifying Open Button And EJECT Button
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Press the EJECT button (B).
Remove the DVD-ROM.
Insert the new DVD-ROM with the white label facing up.
Close the front cover. Do not turn the ignition switch to LOCK (0); watch the navigation screen until the data is down loaded to the navigation unit.
Do the Map Matching (see MAP MATCHING ).

NOTE: After servicing, the front cover and PC card slot door must be closed. If you start up the navigation system with the front cover or PC card slot door open, the display will indicate an error message.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.