Intermediate Shaft Disassembly

Special Tools Required 

• Oil seal driver 07947-SB00100
• Half shaft base 07NAF-SR30101

1. Remove the outer seal (A), and external snap ring (B) from the intermediate shaft (C).
   Fig 1: Identifying Set Ring, Outer Seal And External Snap Ring

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Press the intermediate shaft (A) out of the intermediate shaft bearing (B) using a press. Be careful not to damage the bearing support ring (C) on the intermediate shaft during disassembly.
   Fig 2: Pressing Intermediate Shaft Out Of Intermediate Shaft Bearing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Remove the internal snap ring (A) from the bearing support (B).
   Fig 3: Identifying Internal Snap Ring And Bearing Support

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Press the intermediate shaft bearing (A) out of the bearing support (B) using the 44.5 mm oil seal driver, the half shaft base, and a press.
   Fig 4: Pressing Intermediate Shaft Bearing Out Of Bearing Support

   Courtesy of AMERICAN HONDA MOTOR CO., INC.