Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSACURA2008MDXREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMCONSOLESCENTER CONSOLE REAR TRIM REMOVAL/ INSTALLATION

2008 Acura MDX

Center Console Rear Trim Removal/ Installation

2008 Acura MDXSECTION Center Console Rear Trim Removal/ Installation

Special Tools Required

KTC trim tool set SOJATP2014 *

* Available through the American Honda Tool and Equipment Program; call 888-424-6857

NOTE:

Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
Take care not to scratch the center console and related parts.

Starting at the top, gently pull out the console rear trim (A) to detach the clips (B), then pullout the trim to detach the remaining clips (C), and to release the lower tabs (D), disconnect the connectors, then remove the trim:
- Rear heater-A/C passenger's control panel-unit connector (E)
- With second row seat heater: Second row seat heater switch connectors (F)
- Without rear entertainment system: Accessory power socket connector (G)
- With rear entertainment system: Auxiliary jack connector (G)
  
  Fig 1: Identifying Accessory Power Socket Connector, Clips And Lower Tabs
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the trim in the reverse order of removal, and note these items:
- Make sure all connectors are plugged in properly.
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.