SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2008CSX BASE, K20Z1REPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSMISSIONTRANSMISSION HOUSINGREVERSE IDLER GEAR REMOVAL AND INSTALLATIONINSTALLATION
2008 Acura CSX Base, K20Z1

Reverse Idler Gear Removal and Installation: Installation

2008 Acura CSX Base, K20Z1SECTION Installation
  1. Install the reverse idler gear in the transmission housing.
  2. Lightly coat the reverse idler gear shaft (A), needle bearing (B), and new O-rings (C) with lithium grease.
    Fig 1: Identifying Reverse Idler Gear Shaft, Needle Bearing And O-Rings
    G06265233Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Assemble the new O-rings and needle bearing on the reverse idler gear shaft, then install the reverse idler gear shaft in the reverse idler gear shaft holder (D). Align the D-shaped cut out (E) of the shaft with the D-shaped area (F) of the holder.
  4. Install the reverse idler gear shaft/holder assembly on the transmission housing.
    Fig 2: Identifying Reverse Idler Gear Shaft/Holder Assembly On Transmission Housing
    G06265234Courtesy of AMERICAN HONDA MOTOR CO., INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.