Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2008CSX BASE, K20A3REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 71 (DRIVER POSITION MEMORY SYSTEM (DPMS))DRIVING POSITION MEMORY SWITCH TEST/REPLACEMENT
2008 Acura CSX Base, K20A3
Driving Position Memory Switch Test/Replacement
2008 Acura CSX Base, K20A3SECTION Driving Position Memory Switch Test/Replacement
WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the driver's door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION )
- Disconnect the 7P connector (A) from the driver's position memory switch (B)
- Remove the two screws, then remove the switch from the door panel
- Check for continuity between the terminals in each switch position according to the table
- If the continuity is not as specified, replace the switch
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.