Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2008CSX BASE, K20A3REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 17 (CLIMATE CONTROL SYSTEM)CLIMATE CONTROLRECIRCULATION CONTROL MOTOR REPLACEMENTINSTALLATION
2008 Acura CSX Base, K20A3
Recirculation Control Motor Replacement: Installation
2008 Acura CSX Base, K20A3SECTION Installation
WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
- Make sure the damper lever pins in the motor lever are visible through the holes
- While holding the recirculation control motor (A), install the self-tapping screws and connect the 7P connector (B)
- Reinstall the climate control unit
- After installation, make sure the motor runs smoothly
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.