Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2007TSX AUTOMATICREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLVSA (VEHICLE STABILITY ASSIST) SYSTEMYAW RATE-LATERAL ACCELERATION SENSOR REPLACEMENT
2007 Acura TSX Automatic
Yaw Rate-Lateral Acceleration Sensor Replacement
2007 Acura TSX AutomaticSECTION Yaw Rate-Lateral Acceleration Sensor Replacement
NOTE:
- Do not damage or drop the sensor as it is sensitive.
- Do not use power tools.
- Turn the ignition switch OFF.
- Remove the driver's seat (see FRONT SEAT REMOVAL/INSTALLATION ).
- Lift up the carpet (A).
- Remove the sensor cover (B).
- Remove the yaw rate-lateral acceleration sensor (C) with the bracket (D).
- Remove the bracket.
- Install the sensor in the reverse order of removal.
- Do the VSA sensor neutral position memorization (see VSA SENSOR NEUTRAL POSITION MEMORIZATION ).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.