Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2007TSX AUTOMATICREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLVSA (VEHICLE STABILITY ASSIST) SYSTEMVSA MODULATOR-CONTROL UNIT REMOVAL AND INSTALLATIONREMOVAL
2007 Acura TSX Automatic
VSA Modulator-Control Unit Removal and Installation: Removal
2007 Acura TSX AutomaticSECTION Removal
- Turn the ignition switch OFF.
- Disconnect the VSA modulator-control unit 47P connector (A) by pushing the lock (B) and pulling up the lever (C); the connector disconnects itself.
- Disconnect the six brake lines from the VSA modulator-control unit (D).
- Remove the VSA modulator-control unit with the bracket (E) from the body.
- Remove the VSA modulator-control unit from the bracket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.