Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2007TSX AUTOMATICREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLVSA (VEHICLE STABILITY ASSIST) SYSTEMSTEERING ANGLE SENSOR REPLACEMENT
2007 Acura TSX Automatic
Steering Angle Sensor Replacement
2007 Acura TSX AutomaticSECTION Steering Angle Sensor Replacement
NOTE:
Do not damage or drop the combination switch as the steering angle sensor is sensitive to shock and vibration.
- Remove the steering wheel (see STEERING WHEEL REMOVAL ).
- Remove the steering column covers and the cable reel (see CABLE REEL REPLACEMENT ).
- Remove the combination switch (see STEERING COLUMN REMOVAL AND INSTALLATION ).
- Remove the combination light switch (A) and the wiper/washer switch (B).
- Replace the combination switch body assembly (C).
- Install the combination switch in the reverse order of removal.NOTE:
- Do not remove the steering angle sensor from the combination switch body.
- When installing the cable reel, set the turn signal canceling sleeve position (see INSTALLATION ).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.