Error Codes

2007 Acura TSX AutomaticSECTION Error Codes

The audio system displays error codes when a problem is detected with the disc changer, the disc, the XM radio, or the anti-theft code.

CD Error Codes 

CD ERROR CODES

Error Code Displayed Possible Cause Solution
DISC Cannot read disc. Eject the disc and try another one.
DISC ERROR There is a problem with the disc player. A common problem is disc labels coming off the disc in the player. Try to eject the disc and try another one. If there is still a problem, replace the audio unit.
DISC FORMAT A disc was inserted that has a format that is not recognized. Eject the disc and try another one.
DISC-H Disc player is hot. This can happen if the vehicle is parked out in the hot sun all day. Park the vehicle in a cooler place for a while and try the disc player again. If the error code is still present, try another disc. If the error code is still present, replace the audio unit.

XM Error Codes 

XM ERROR CODES

Error Code Displayed Possible Cause Solution
LOADING XM radio acquiring audio or program information Wait until the radio has received the information.
OFF AIR XM channel not in service. Try another XM channel.
NO SIGNAL Loss of signal. Both terrestrial and satellite antennas have lost signal. Park the vehicle outside with a clear view of the southern horizon.
UPDATING XM radio is receiving information update from the network. This message will disappear once the update is done.
ANTENNA XM antenna error. Repair the open or short in the terrestrial or satellite antenna. Substitute the XM antenna and recheck. If the error is gone, replace the original XM antenna harness. If the error is still present, replace the XM antenna lead.
CHECK ANTENNA
-- No signal from XM. Check known-good vehicle with XM radio. If the known-good vehicle has the same symptoms, contact XM Satellite Radio at (800) 852-9696.

Audio Unit Error Codes 

AUDIO UNIT ERROR CODES

Error Code Displayed Possible Cause Solution
ERROR 1 Anti-theft code mismatch (1st try). Enter the correct anti-theft code.
ERROR E Anti-theft code mismatch (10th try). Remove fuse No. 6(10 A) in the under-dash fuse/relay box, then reinsert it. You will have 10 more tries to enter the correct anti-theft code.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.