Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSACURA2004TL AUTOMATICREPAIR AND DIAGNOSISENGINE MECHANICALMECHANICALENGINE REMOVAL AND INSTALLATIONENGINE INSTALLATION

2004 Acura TL Automatic

Engine Installation

2004 Acura TL AutomaticSECTION Engine Installation

Special Tools Required

Front subframe adapter VSB02C000016
Engine support hanger, A and Reds AAR-T-12566
Engine hanger balance bar VSB02C000019
These special tools are available through Acura Tool and Equipment Program, 1-888-424-6857
1. Install the engine mount brackets and accessory brackets, and tighten their bolts to the specified torques.
  
  Fig 1: Engine Brackets With Torque Specifications
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Position the engine/transmission under the vehicle. Be sure that they are properly aligned. Carefully lower the vehicle until the engine/transmission are properly positioned in the engine compartment. Make sure the vehicle is not resting on any part of the engine/transmission. Support the engine/transmission with a chain hoist (A) and carefully raise the engine/transmission into place.
  NOTE: Reinstall the mounting bolts/support nuts in the sequence given in the following steps. Failure to follow this sequence may cause excessive noise and vibration, and reduce engine mount life.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.