Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC B1706: Display Panel Control Unit Lost Communication with the Gauge Control Module (VSS/NE Signal)
2004 Acura TL AutomaticSECTION DTC B1706: Display Panel Control Unit Lost Communication with the Gauge Control Module (VSS/NE Signal)
NOTE:
- Display panel control unit DTCs may not clear using the HDS. If the DTCs will not clear, manually reset the display panel control unit (see GENERAL TROUBLESHOOTING INFORMATION ).
- If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN system diagnosis test mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A ).
- Clear the DTC with the HDS.
- Turn the ignition switch OFF, and then back ON (II).
- Check for DTCs with the HDS.
Are DTCs B1011, B1060, and B1805 indicated?
- YES- Go to the Gauge Control Module Input Test (see GAUGE CONTROL MODULE INPUT TEST ).
- NO- Replace the display panel control unit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.