Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA20043.5RLREPAIR AND DIAGNOSISRESTRAINTSAIR BAG, SRSAIR BAG RESTRAINT SYSTEMSREMOVAL & INSTALLATIONSRS UNITINSTALLATION
2004 Acura 3.5RL
SRS Unit: Installation
2004 Acura 3.5RLSECTION Installation
- Install new SRS unit. Tighten new Torx bolts to 87 INCH lbs. (9.8 N.m). Connect SRS main harness connector and SRS floor harness connector to SRS unit. See Fig 3 . Install bracket. Install radio/climate control panel assembly. See Fig 2 . Install console panel and automatic transmission (A/T) gear position indicator trim to center console. See Fig 1 .
- Activate air bag system and seat belt tensioner system. See DISABLING & ACTIVATING AIR BAG SYSTEM . After installation, check system for proper operation. See SYSTEM OPERATION CHECK .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.