Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Erasing DTC Memory Using SCS Service Connector
2004 Acura 3.5RLSECTION Erasing DTC Memory Using SCS Service Connector
- Turn ignition off. Connect SCS Short Connector (07PAZ-0010100) to Memory Erase Signal (MES) connector. See Fig 1 .
- Turn ignition on. SRS indicator light will come on for about 6 seconds then go off.
- Disconnect SCS short connector from MES connector within 4 seconds after SRS indicator light goes off. SRS indicator light will come on again.
- Reconnect SCS short connector to MES connector within 4 seconds after SRS indicator light comes on. SRS indicator light will go off.
- Disconnect SCS short connector from MES connector within 4 seconds. SRS indicator light will indicate that memory is erased by blinking 2 times.
- Turn ignition off, and wait 10 seconds before proceeding with troubleshooting.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.