Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Maintenance Service Reminder Reset - Procedure 04
2004 Acura 3.5RLSECTION Maintenance Service Reminder Reset - Procedure 04
- At 5900-6100 miles MAINT REQ'D light blinks for 10 seconds when the ignition switch is turned to ON (II) position. At 7400-7600 miles MAINT REQ'D light illuminates and stays on while ignition switch is in ON (II) position.
- To reset MAINT REQ'D light, turn ignition switch to OFF position. Push and hold the Trip or Select and the reset buttons simultaneously. Turn ignition switch to ON (II) position, and continue to hold buttons for more than 10 seconds.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.