Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Draining & Refilling
Warm transaxle to normal operating temperature. Remove transaxle drain plug. Use NEW gasket and replace drain plug whenever fluid is drained. Tighten drain plug to specification. See TORQUE SPECIFICATIONS . On MDX and 3.2CL models, remove fill plug and refill transaxle between upper and lower marks on dipstick. Tighten fill plug to specification. See TORQUE SPECIFICATIONS . On all other models, refill transaxle through dipstick hole. On all models, check and adjust fluid level as necessary. See CHECKING FLUID LEVEL .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.