Glove Box Removal/Installation

SRS components are located in this area. Review the SRS component locations and precautions and procedures in the SRS section before performing repairs or service. See AIR BAG RESTRAINT SYSTEMS.

1. If it is necessary to remove the glove box cover, remove the passenger's front console cover first (see CONSOLE PANEL REMOVAL/INSTALLATION  ).
2. Remove the glove box (A):
   • Remove the screw (B), then remove the damper (C) from the glove box.
   • While holding the glove box, remove the glove box stop (D) on each side.
   • Remove the screws (E), then remove the glove box.

   Fastener Locations 

   Fig 1: Removing The Glove Box

   
3. While pulling out on the bottom of the right dashboard side cover (F), pry the rear edge portions (G) of the cover to detach the clips (H). Release the hook (I), then remove the cover.
4. Remove the screws (J and K), and detach the clips (H and L). Disconnect the trunk lid opener main switch connector (M) and glove box light bulb socket (N), and detach the harness clip (O), then remove the glove box cover (P).
5. Install the glove box in the reverse order of removal, and note these items:
   • Replace any damaged clips.
   • Make sure the connector and glove box light bulb socket are plugged in properly.
   • Push the clips of both the glove box cover and the dashboard side cover into place securely.