SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA20043.5RLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 56 (INTERIOR LIGHTS)INTERIOR LIGHTSCEILING LIGHT TEST
2004 Acura 3.5RL

Ceiling Light Test

2004 Acura 3.5RLSECTION Ceiling Light Test
WARNING: This page is about a different car, the 2003 Acura 3.2CL, 2002 Acura 3.2CL, and 2001 Acura 3.2CL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the light switch OFF.
  2. Carefully pry off the lens (A) with a small screwdriver.

    CEILING LIGHT:  7W

    Fig 1: Prying Off The Ceiling Light Lens
    G01165027Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the two mounting nuts.
  4. Disconnect the 3P connector (B) from the housing (C).
  5. Check for continuity between the terminals in each switch position according to the table.
    Fig 2: Ceiling Light Switch Continuity Test Chart
    G01165028Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. If the continuity is not as specified, check the bulbs (D).

    If the bulbs are OK, replace the light.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.