Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal (3.5RL)
2004 Acura 3.5RLSECTION Removal (3.5RL)
WARNING: This page is about a different car, the 2001 Acura MDX, 2001 Acura Integra, 2001 Acura 3.5RL, 2001 Acura 3.2TL, and 2001 Acura 3.2CL. However, it is still accessible from the selected car via links, so may be relevant.
- If vehicle is equipped with Traction Control System (TCS), disconnect TCS control valve angle sensor connector and actuator connector. Disconnect vacuum and coolant hoses, breather pipe and air hose from intake air duct. Loosen intake air duct band screws and remove intake air duct. Remove TCS control valve assembly and bracket.
- On all models, disconnect throttle cable and cruise control cable (if equipped) at throttle body. Label and disconnect hoses and wiring from throttle body. Drain coolant until level drops below throttle body. Remove retaining nuts or bolts and throttle body.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.