Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA20043.5RLREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 36 (FRONT SUSPENSION)REMOVAL & INSTALLATIONSTRUTSREASSEMBLY
2004 Acura 3.5RL
Removal & Installation: Struts: Reassembly
2004 Acura 3.5RLSECTION Reassembly
WARNING: This page is about a different car, the 2003 Acura 3.2CL, 2002 Acura 3.2CL, and 2001 Acura 3.2CL. However, it is still accessible from the selected car via links, so may be relevant.
- Install strut unit on a commercially available strut spring compressor (A). Assemble strut in reverse order of removal except for washer and self-locking nut. Align bottom of strut spring and spring lower seat (B). See Fig 1 .
- Position mount base (A) on strut unit. See Fig 2 . Compress strut spring with spring compressor.
- Install rubber bushing, washer (A), and a NEW 10 mm self-locking nut (B). See Fig 3 .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.