Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Start Up Procedure
Turn ignition switch to ACC position. Press MENU key on display. Main menu screen should appear. Press and hold keys in this order: MENU key, MAP/GUIDE key, then CANCEL key. Keep them pushed simultaneously for 5 seconds. Display should change to DIAGNOSIS MENU screen. Diagnostic menu options available are: SYSTEM LINKS, MONITOR CHECK, UNIT CHECK, TIRE CALIBRATE, YAW RATE, CYCLIC DIAG and IN-LINE DIAG. Touch item you want to check. To return to previous screen, touch RETURN key.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.