Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA20043.5RLREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSCOMPONENT TESTSA/T GEAR POSITION SWITCH3.2TL
2004 Acura 3.5RL
A/T Gear Position Switch: 3.2TL
2004 Acura 3.5RLSECTION 3.2TL
- Disconnect A/T gear position switch 10-pin harness connector. Using ohmmeter, check continuity between specified terminals in relation to shift lever position. See Fig 1. See A/T GEAR POSITION SWITCH CONTINUITY (3.2TL) table.
- If continuity is not as specified, A/T gear position switch may require adjustment. See A/T GEAR POSITION SWITCH under ADJUSTMENTS. If correct continuity cannot be obtained by adjusting A/T gear position switch, replace A/T gear position switch.
A/T GEAR POSITION SWITCH CONTINUITY (3.2TL)
| Shift Lever Position | Check Continuity Between Terminals No. |
|---|---|
| P | 1, 3 & 10 |
| R | 3 & 9 |
| N | 1, 3 & 8 |
| D4 | 2, 3 & 7 |
| D3 | 2, 3 & 6 |
| 2 | 2, 3 & 5 |
| 1 | 3 & 4 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.