Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Rear Cover: Disassembly
2004 Acura 3.5RLSECTION Disassembly
- To remove 2nd clutch feed pipe, remove snap ring, feed pipe guide, "O" rings and 2nd clutch feed pipe. See Figure.
- To remove reverse clutch feed pipe, remove snap ring, oil feed guide, "O" rings, feed pipe guide and reverse clutch feed pipe.
- To remove reverse idler gear, remove bolts, reverse idle gear shaft holder and dowel pins. Remove reverse idler gear shaft, thrust washer, reverse idle gear, needle bearings and thrust washer.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.