Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSACURA20043.5RLREPAIR AND DIAGNOSIS (SINGLE PAGE)STEERINGSTEERING COLUMNSREMOVAL & INSTALLATIONSTEERING COLUMN ASSEMBLYINSPECTION (ALL MODELS)

2004 Acura 3.5RL

Inspection (All Models)

2004 Acura 3.5RLSECTION Inspection (All Models)

Check the steering column bearing and the steering joint bearings for play and proper movement. If any bearing is noisy or has excessive play, replace the steering column as an assembly (all models).
On 3.2CL, 3.2TL & MDX only, check the retaining collar for damage. If it is damaged, replace the steering column assembly. See Fig 1 or Fig 3 .
On 3.2CL and 3.2TL only, check the absorbing plates for distortion or breakage. If there is distortion or breakage, replace the steering column assembly. See Fig 1 .
On 3.5RL and MDX only, check the absorbing plates, absorbing plate guides and sliding capsules for distortion or breakage. The sliding capsule is attached to the column with plastic injections. See Fig 3 or Fig 4 .
On 3.5RL only, for tilt/extend-retract motors and sensors (Driving Position Memory System) inspection, see appropriate STEERING COLUMN SWITCHES article in ACCESSORIES & EQUIPMENT. See also, Fig 5 .
On RSX only, check the sliding capsules for distortion and breakage. If there is distortion or breakage replace the steering column assembly. See Fig 2 .

Fig 1: Exploded View Of Steering Column Tilt Lever Component (3.2CL & 3.2TL)

Courtesy of AMERICAN HONDA MOTOR CO., INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.