SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA20043.5RLREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSCOMMON SPECS & PROCEDURESBRAKESDISC BRAKESBRAKE SERVICE SPECIFICATIONS
2004 Acura 3.5RL

Brake Service Specifications

2004 Acura 3.5RLSECTION Brake Service Specifications
DISC BRAKE SPECIFICATIONS

Application In. (mm)
Parallelism .0006 (.015)
Maximum Runout (1)
Front .004 (.10)
Rear .006 (.15)
Standard Thickness
Front .90-.91 (22.9-23.1)
Rear .469-.476 (11.9-12.1)
Minimum Refinish Thickness (2)
Front 1.02 (26.0)
Rear .39 (10.0)
Parking Brake Drum (Rear)
Diameter
Standard 6.689-6.693 (169.9-170.0)
Service Limit 6.732 (171.0)
Lining Thickness
Standard .075-.098 (1.9-2.5)
Service Limit .04 (1.0)
Disc Pad Standard Thickness
Front .41-.45 (10.5-11.5)
Rear .33-.37 (8.5-9.5)
Limit .06 (1.6)
(1) Measured 0.4" (10 mm) from outer edge of rotor. Resurface rotor if runout exceeds specification.
(2) Use discard thickness stamped on rotor if different from minimum refinish thickness shown in table.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.