Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA20043.5RLREPAIR AND DIAGNOSIS (SINGLE PAGE)EXTERNAL PAGESDIFFERENT CARSECTION 53 (POWER STEERING SYSTEM)
2004 Acura 3.5RL
Section 53 (Power Steering System)
2004 Acura 3.5RLSECTION Section 53 (Power Steering System)
WARNING: This page is about a different car, the 2003 Acura 3.2CL, 2002 Acura 3.2CL, and 2001 Acura 3.2CL. However, it is still accessible from the selected car via links, so may be relevant.
- Special Tools
- Component Location Index
- Symptom Troubleshooting Index
- Hard Steering Troubleshooting
- Steering Wheel Rotational Play Check
- Power Assist Check
- Steering Linkage and Gearbox Inspection
- Pump Pressure Test with T/N 07406-0010001
- Pump Pressure Test with T/N 07406-001000A
- Fluid Leakage Inspection
- Pump Belt Inspection and Adjustment
- Fluid Replacement
- Hoses, Lines, and Pressure Switch Replacement
- Pump Replacement
- Pump Overhaul
- Steering Wheel Removal
- Steering Wheel Disassembly/Reassembly
- Steering Wheel Installation
- Steering Column Removal and Installation
- Steering Column and Tilt Lever Inspection / Adjustment
- Steering Lock Replacement
- Rack Guide Adjustment
- Steering Gearbox Removal
- Steering Gearbox Overhaul
- Steering Gearbox Installation
- Tie-Rod Ball Joint Boot Replacement
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.