Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
RSX, 3.2CL & 3.2TL
Obtain radio anti-theft code from customer, and make note of selected radio presets. Disconnect negative battery cable. Loosen fuel tank filler cap. Place wrench on fuel pulsation damper at fuel rail, next to throttle cable. Place clean shop rag over fuel pulsation damper. Slowly loosen fuel pulsation damper one complete turn to relieve system pressure. Always replace washer after loosening or removing fuel pulsation damper. Tighten fuel pulsation damper to 16 ft. lbs. (22 N.m). Reprogram radio anti-theft code and radio station presets.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.