Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA20043.5RLREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALSTARTERSOVERHAULSTARTERREASSEMBLY
2004 Acura 3.5RL
Engine Mechanical: Starters: Overhaul: Starter: Reassembly
2004 Acura 3.5RLSECTION Reassembly
- Pry back each brush spring with a screwdriver. Position the brush about halfway out of its holder, and release the spring to hold it there. See Fig 1 .
- Install the armature in the housing. Pry back each brush spring again, and push the brush down until it seats against the commutator, release the spring against the end of the brush. See Fig 2 .
- Install the starter and cover (A) to retain the brush holder (B). See Fig 3 .
NOTE:
For reassembly, see Figure
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.