Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA20043.5RLREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALSTARTERSOVERHAULSTARTEROVERRUNNING CLUTCH
2004 Acura 3.5RL
Overrunning Clutch
2004 Acura 3.5RLSECTION Overrunning Clutch
- Put the end of a pipe (inner diameter .51" (13 mm)) against the pinion stop, and strike the pipe to force the pinion stop over the spring clip. See Fig 1 .
- Remove the spring clip, pull the pinion stop and overrunning clutch off the shaft. See Fig 2 .
NOTE:
Be careful not the damage the planetary gear shaft when striking the pipe.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.