Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Differential Assembly: Installation
To install, reverse removal procedure. If differential case is replaced, replace 26-mm shim. Fill extension shaft and transmission 36-mm sealing bolt with Super High-Temp Urea Grease (08798-9002) and replace extension shaft set ring. Use Extension Shaft Installer (07MAF-PY40100) to install extension shaft. Apply Liquid Gasket (08718-0001) to right engine mount bracket bolts. Fill differential with oil. Tighten engine mount bracket bolts to specification. See TORQUE SPECIFICATIONS .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.