Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal & Installation
2004 Acura 3.5RLSECTION Removal & Installation
- Remove steering column and steering wheel. See STEERING COLUMN article in STEERING. Remove the combination switch. Remove the circlip and screw, then remove the steering angle sensor from the combination switch. See Fig 1 .
- Install in the reverse order of removal. Perform the Steering Angle Sensor Neutral Position Memorizing, procedure. See STEERING ANGLE SENSOR NEUTRAL POSITION CHECK & MEMORIZING under PROGRAMING.
CAUTION:
Do not apply any grease or oil to the steering angle sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.