Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA20043.5RLREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEPOWER WINDOWSREMOVAL & INSTALLATIONPOWER WINDOW MOTORREMOVAL (FRONT)
2004 Acura 3.5RL
Removal (Front)
2004 Acura 3.5RLSECTION Removal (Front)
- Remove door panel and plastic cover. See DOOR PANEL . On 3.5RL, remove inner window molding. On all models, ensure power window switch is connected. Raise window glass until mounting bolts are visible. Using a grease pencil, mark original adjustment position of stopper plates.
- Mark original adjustment position of glass mounting bolts and remove bolts. Carefully slide glass out through window slot. Disconnect electrical connector and harness clip from door. Remove power window motor and regulator mounting bolts "A". See Fig 1 . Loosen power window motor and regulator mounting bolts "B". Remove power window motor and regulator through hole in door. Remove power window motor from regulator.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.