Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Keyless Receiver Unit Input
Remove 2 bolts below rear seat lower cushion and seat lower cushion. Remove rear seat headrests. Remove center seat belt from guide. Remove 4 bolts below and 4 bolts behind rear seat back. Remove 2 clips from trunk area and rear seat back. Disconnect keyless receiver unit 7-pin connector. Inspect connectors and terminals. Check for bent, loose or corroded terminals. Perform keyless receiver unit input test. See Fig 1 . Repair as necessary and recheck system operation. If input test is okay, replace keyless receiver unit and recheck system operation.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.