Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Cruise Control Main Switch: 3.5RL
2004 Acura 3.5RLSECTION 3.5RL
- Remove Traction Control System (TCS) and cruise control main switch from driver's switch panel. Disconnect cruise control main switch 5-pin connector. With switch in OFF position, continuity should exist between cruise control main switch terminals No. 1 and 2, and between terminals No. 4 and 5. See Fig 1. Go to next step.
- With cruise control main switch in ON position, continuity should exist between cruise control main switch terminals No. 1 and 2, and between terminals No. 3, 4 and 5. See WIRING DIAGRAMS . If continuity is not present as specified, replace cruise control main switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.