Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2003MDX TOURINGREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR BODY PANELSDOORSFRONT DOOR PANEL REMOVAL/INSTALLATION
2003 Acura MDX Touring
Front Door Panel Removal/Installation
2003 Acura MDX TouringSECTION Front Door Panel Removal/Installation
Special Tools Required
- KTC trim tool set SOJATP2014
- Trim pad remover, Snap-on A 177A or equivalent
NOTE: Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Remove the mirror mount cover (see step 2 in POWER MIRROR REPLACEMENT ). Take care not to scratch the door panel.
- Remove the inner handle (A). Take care not to scratch the door panel.
- -1 Pry out the cap (B), and remove the screw (C).
- -2 Pull the inner handle forward and out half-way.
- -3 Disconnect the inner handle rod (D) from the joint bushing (E), and power door lock switch connector (F). For some models: On driver's side, disconnect the driving position memory switch connector (G).NOTE: Check the bushing for damage, and replace if necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.