SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA20033.2CL BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 4 (ENGINE CONTROLS - REMOVAL, OVERHAUL & INSTALLATION)COMPUTERIZED ENGINE CONTROLSPOWERTRAIN CONTROL MODULE (PCM)REMOVAL & INSTALLATION (MDX)
2003 Acura 3.2CL Base

Removal & Installation (MDX)

2003 Acura 3.2CL BaseSECTION Removal & Installation (MDX)
WARNING: This page is about a different car, the 2001 Acura MDX, 2001 Acura Integra, 2001 Acura 3.5RL, 2001 Acura 3.2TL, and 2001 Acura 3.2CL. However, it is still accessible from the selected car via links, so may be relevant.

PCM is located in front and to right of console. Disconnect negative battery cable. Remove passenger side console trim. Remove bolt holding intake manifold runner control (IMRC) module. Remove two nuts holding IMRC module bracket. Remove bolt and nut from PCM. Remove PCM connectors. Remove PCM. To install, reverse removal procedure.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.