Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P1106: Barometric Pressure Sensor Range/Performance
Perform ECM/PCM reset procedure. See ECM/PCM RESET PROCEDURE/CLEARING DIAGNOSTIC TROUBLE CODES under SELF-DIAGNOSTIC SYSTEM. Start engine and hold at 3000 RPM, no load in park or neutral, until cooling fan comes on. Allow engine to idle. Test drive vehicle with A/T in "2" position or M/T in 4th gear. Accelerate for 5 seconds using Wide Open Throttle (WOT). If DTC P1106 does not reset, problem is intermittent. System is okay at this time. If DTC P1106 resets, update ECM/PCM or substitute with known-good ECM/PCM. If symptom or indication goes away, replace original ECM/PCM.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.