Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2001INTEGRA GS, 2D COUPE, STANDARDREPAIR AND DIAGNOSISHEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSHEATER SYSTEMTESTINGHEATER CONTROL PANELHEATER FAN SWITCH
2001 Acura Integra GS, 2D Coupe, Standard
Heater Fan Switch
2001 Acura Integra GS, 2D Coupe, StandardSECTION Heater Fan Switch
- Remove heater control panel. See HEATER CONTROL PANEL under REMOVAL & INSTALLATION. With heater fan control lever (heater fan switch) in OFF position, no continuity should exist between terminals of 6-pin connector. See Figure .
- With fan control lever at 1, continuity should exist between terminals "A", "D" and "F". With fan control lever at 2, continuity should exist between terminals "A", "B" and "F".
- With fan control lever at 3, continuity should exist between terminals "A", "E" and "F". With fan control lever at 4, continuity should exist between terminals "A", "C" and "F". If continuity is not as specified, replace heater fan switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.