Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Radio Security Code
Radio will require anti-theft security code to be entered if battery is disconnected. Turn radio on. Radio should display "code". Using first 4 preset buttons, enter code number from customer supplied security card. Each preset button applies to code number digit. For example, No. 1 button sets the first digit of code number. Cycle button until desired number appears. Once code is entered, press TAPE or CD (as applicable) button. A "beep" will sound when correct code is entered. If code is incorrectly entered after 3 sucessive attempts, radio must be left on for one hour before it will accept code entry.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.