Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA1998INTEGRA RS, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 6 (COMPUTER RELEARN PROCEDURES)ISUZUHOMBREPASSWORD (PASSLOCK) REPROGRAMMING AUTO LEARN (30-MINUTE PROCEDURE)
1998 Acura Integra RS, Automatic
Password (PASSLOCK) Reprogramming Auto Learn (30-Minute Procedure)
1998 Acura Integra RS, AutomaticSECTION Password (PASSLOCK) Reprogramming Auto Learn (30-Minute Procedure)
WARNING: This page does not describe the selected car, but rather 135 other vehicles, including the 2000 Volvo V70, 2000 Volvo V40, 2000 Volvo S80, 2000 Volvo S70, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
- Reprogramming learn procedure must be performed if Body Control Module (BCM), Powertrain Control Module (PCM), Vehicle Control Module (VCM), or passlock sensor has been replaced. A password is communicated between BCM and PCM/VCM to provide engine operation. If PCM/VCM has been replaced, the PCM/VCM must learn the password from the BCM.
- Attempt to start engine. Engine will start and then stall. After engine stalls, leave ignition on for 10 minutes. SECURITY indicator light will illuminate for 10 minutes and then go off. The SECURITY indicator light is located on center of instrument panel, just above the turn signal indicators.NOTE: Ensure battery is fully charged before proceeding. Ensure steps are followed in correct order or procedure may need to be repeated.
- After SECURITY indicator light goes off, turn ignition off for 5 seconds. Attempt to start engine and then leave ignition on. After engine has stalled, leave ignition on for 10 minutes. SECURITY indicator light will illuminate for 10 minutes and then go off. After SECURITY indicator light goes off, turn ignition off for 5 seconds.
- Attempt to start engine and then leave ignition on. After engine has stalled, leave ignition on for 10 minutes. SECURITY indicator light will illuminate for 10 minutes and then go off.
- Turn ignition off for 5 seconds. Turn ignition on and attempt to start engine. If engine starts, password learn procedure is complete. If engine does not start, ensure procedure was properly followed. If procedure was properly followed, check for DTCs. If any DTCs exist, perform test procedures for specified DTC and repair as necessary. See appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.