SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA1998INTEGRA RS, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 29 (MULTIPLEX CONTROL SYSTEM)RESETTING PCM IDLE MEMORY
1998 Acura Integra RS, Automatic

Resetting Pcm Idle Memory

1998 Acura Integra RS, AutomaticSECTION Resetting Pcm Idle Memory
WARNING: This page is about a different car, the 1997 Acura 3.5RL. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When battery cables or BACK-UP RADIO fuse (7.5-amp) are disconnected, Powertrain Control Module (PCM) idle control is erased from PCM memory. Perform following procedure after battery cables or BACK-UP RADIO fuse (7.5-amp) are reconnected.

Start engine. Ensure A/C switch is in OFF position, headlights are off, rear defogger switch is in OFF position, and transmission is in Neutral or Park. Set engine speed to 3000 RPM until radiator cooling fan comes on. When radiator cooling fan comes on, reduce engine speed and allow engine to idle for approximately 5 minutes.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.